ENDO Withered Foxy (privat)

by ChaosVR in Workshop > 3D Design

71 Views, 0 Favorites, 0 Comments

ENDO Withered Foxy (privat)

image_2024-08-24_112319433.png

Endo Instruction

Supplies

Printing

i think u can handle that urself ;)

Servos

image_2024-08-24_113710659.png
image_2024-08-24_113833710.png
image_2024-08-24_113933494.png
image_2024-08-24_114119125.png
image_2024-08-24_114336922.png

Endo Assembly

image_2024-08-24_114739563.png
image_2024-08-24_115037246.png
image_2024-08-24_115509452.png
image_2024-08-24_115750572.png

Screwholes for attaching marked red

Eyes

image_2024-08-24_123935303.png
image_2024-08-24_123952943.png
image_2024-08-24_124010798.png
image_2024-08-24_124036489.png
image_2024-08-24_124103310.png
image_2024-08-24_124128953.png
image_2024-08-24_124144553.png
image_2024-08-24_124209219.png
image_2024-08-24_124236016.png
image_2024-08-24_124259690.png
image_2024-08-24_124358413.png
image_2024-08-24_124415147.png
image_2024-08-24_124457481.png
image_2024-08-24_124511513.png
image_2024-08-24_124540703.png
image_2024-08-24_124555113.png
image_2024-08-24_124744943.png
image_2024-08-24_124832786.png

Ears

image_2024-08-24_125000247.png
image_2024-08-24_125232740.png
image_2024-08-24_125445003.png

For The Ears I use a special technique I learned.


U start by putting the ear right at the Servo.

Then u get a screw and screw it in through the ear in the servo.

When it hits the red marked spot in the ear. it will start pulling the servo inside of the of the ear.

Once its fully inside stop screwing and U are done