Dog Treat Dispenser

This dog treat dispenser makes it easier for you to treat your dogs.
Body

Take a cube and make it 1 ft ( 304.8 mm) high,and 51 mm wide. hollow out the inside.
Entrance

take a hollowed out cube and put it on the bottom.(leave space for later)
Slide

take a roof and put half of it inside and half outside. Then take a hollowed out cube and slant it onto the roof to form a slide.
Door


Take 1 cube and squish it. double it. Then take another cube make it a bigger size than the entrance from step #2. double it put 1 to the side and hollow the other and put it through the other 2 squished cubes. put a cylinder for a handle on the other 1 on the side. Leave it on the side to print.
Dog Treat Hole

take a hollowed cylinder and put it on the top of it .

print the dog treat dispenser.
DOG TREATS!!!!!

put dog treats in it for your dog to enjoy.