Diy Table Saw

Cheap but effective diy table saw.

I built this table saw using a 48" x 32" offcut of 3/4" mdo plywood

I use a 245mm circular saw.

I cut off 1ft off the longer side leaving a 3ftx32" table.

I cut the 1ft piece into 3 lengths 4" wide 2 for fence and 1 for the crosscutting sled.

I screwed them into L sections using 2" screws.

I mounted them into scrap 4x2 and then into ball bearing draw slides.

I then mounted thumb screws to hold in position. Not shown on pictures.

I mounted it on 32" 4x4 posts.