Diy Old Style Lamp

For this project you will need :

• An old light bulb
• The outline of a small broken 12 volt motor
• A wooden board
• Some wire
• A DC jack connector

We need to cut the L-shape of the lamp.

Now we need to cut the hole for the wire of the light bulb.

We need to solder the wires to the light bulb so we can make it work.

We need to put our light bulb in the broken motor. We also have to run the wires through the motor hole. Be careful not to touch the bulb contact with the motor because there could be a short circuit so you should put electrical tape on the bulb contact.

Now we have to aim the motor on the lamp and we have to pass the wire trough the hole we made earlier.

Now we have to cut the base of the lamp.

Now we can attach the base to the rest of the lamp . And we can sand our lamp and attach the DC jack connector to the light bulb wire. You can now enjoy your diy lamp.