Diy File Sander Handle

Recently i faced a problem while sanding some of my soldering iron tip that it was tough for me to use the file due to improper stability because it does not have handle attached to it ......So i decided to make one

Before starting i wish to list items required

• Sanding file (probably most important)
• A fevicol bottle (anything which is hollow and can be used as a mould {choose something whose neck region is big enough to hold the file} )
• Hot glue gun
• Lots of glue sticks
• Paper cutter and some basic tools
• Sandpaper
• Tape
• Paint

Take your bottle and cut the bottom of the bottle so that you have now access to the hollow part. (DO NOT CUT THE NECK REGION ).After cutting make sure to clean the bottle ........And choose a base

After the bottom is cut and the file is nicely fit start adding hot glue from the bottom . You can add tape on the neck region so that hot glue do not escape out . After the mould (fevicol bottle) is fully filled add a brown tape at its bottom and keep it straight on a surface .

As we know hot glue is hot is sink that whole thing in cold water so the cooling action will be more fast

After the hot glue had cooled down its time to remove the mould ...Just take a scissor or a wire cutter to cut a notch and tear the whole mould with the help of that notch.

Finally its time to give it a nice finish .......I love orange so i painted it orange!!

After paint has dried you have successfully made a handle for your file

This was my first instructable so if i did any mistake please let me know in my comments section

catch me on You Tube

https://www.youtube.com/channel/UCy94qlZwIAEYNJZO-...

Facebook

https://www.facebook.com/aman.singhal.7921