Digital Clock From Scratch Using LEDs and 89C51

Digital Clock using LED’s and 89C51 from scratch

In this Instructable, I will show you how to make Microcontroller Based Digital Clock using LED’s and Atmel 89C51 from scratch.

Its an Alarm clock and also indicates the PM and AM times LED.

Components we need are

121 LED’s

1 Atmel 89C51

1 40 pin IC base

1 LM 7805

2 20pin SIL connectors (male and female)

1 vero board

117 Resistance 330 ohm

4 Buttons

1 switch

1 usb cable

1 power bank (optional)

1 paper box

1 white paper

1 needle

1 Buzzer(optional)

1 16 Mhz crystal oscillator

2 33pF capacitors

First of all you need the 8 Segment Design for that I use the proteus to design the 8 segment and got a print of that. After printing the segments use hard paper and attach the white segmented paper upon it using gum. Make holes on the LED footprint of all segments just like in the picture below.

After making the holes place LED’s always remember to note the terminals of LED’s.

First Cut a Piece of vero board . Attach components to Board . I use 40 pin IC base so that it could be easily programmed and place to the board.Use the schematic diagram to implement the circuit. I have not the alarm but you can use it. And also set the am and pm time LED’s indications. Attach the wires to the LED panel and use the SIL connectors of 20 pins for each sides.

Cut the small piece of vero Board . place 4 push buttons for the time and alarm.

Now time to give a life to the Clock yeh! Its programming time.open the code in keil and make the HEX file after that burn that HEX file into the 89C51.

Last step is to case the whole into a plastic box as shawn in figure. All Done must Comment thanks alot for your views.Video Will show how its work and look like.

Attachments:

Docx file

Code HEX file.

LED print PDF.