Dice Rolling Arena!

Welcome to the Dice Rolling Arena Build! This is a wooden Arena to roll dice in for Tabletop Games. Great for Dungeons and Dragons, Monopoly, or any other Tabletop Game you might need to roll a Die for.

You can get this full plan and more at https://www.weilwood.com/post/how-to-build-a-dice-rolling-arena

Lumber Finished to 3/4 of an inch

Felt

Wood Glue

Sheet of Cardboard

Super Glue

Brad Nails

Recommended Wood
For this build use a Hardwood which will be sturdy for the best product. Good options include Oak, Walnut, or Cherry, though other woods will work. If building for outdoor use Cedar would be a good choice. For a special look use a different wood for the for parts A and B.

Table Saw (Or Circular saw or rip saw will work)

Miter Saw

Clamps or weights

Hammer Sandpaper

Square

Brad Nailer

Cut all parts out on a table saw or using another cutting method. With Part A glue together all 6 Pieces with glue at each miter joint. Allow to dry for a few hours While waiting, use glue to cover one side of the card board in felt Using Superglue glue the Cardboard to the bottom of the hexagon, make sure the when looking through the hexagon you can see the felt. On the back side of the cardboard line up part C and glue the piece down lining it up. Then Place 2 brad nails on each side (12 total), make sure to take care so nails don't shoot through the sides. Glue Part B around the outside of the Hexagon so that it hides the seem between part C and the Part A Hexagon. Sand Finish as you wish.

Part Diagrams The following diagram shows the pieces which need to be cut.