Desktop Catapult With Storage

by CrystalO14 in Outside > Siege Engines

2197 Views, 6 Favorites, 0 Comments

Desktop Catapult With Storage

KIMG1027.jpg

I teach a desktop weaponry class with middle school aged homeschoolers. I wanted to have them build a simple catapult with items they could most likely find around the house, but that also had storage in the base for ammo. This quick, fun project fits both those desires.

Happy building!

Materials

KIMG0975.jpg
  • 1-3 in x 1.25 in x 1 in cardboard jewelry box with removable lid
  • 2-full length craft sticks
  • 2-3/4 length craft sticks
  • 6-1/2 length craft sticks (tip: cut 3 craft sticks in 1/2)
  • 1-jumbo craft stick
  • 1 Rubber Band
  • 1 condiment cup
  • Pencil top erasers or other small ammo
  • Duct tape
  • Glue gun and glue

Not pictured: scissors

Attach Uprights

Effect_20180117_193901.jpg

Remove the lid from the box and place upside down. Glue the full sized craft sticks to the middle of the long side of the lid so they are pointing up. For the rest of the directions, these will be called the uprights.

Add Bracing

KIMG1023.jpg

Glue a 1/2 length craft sick at an angle, attaching it to the lid and the upright as shown. Do this to both sides.

Prepare Upper Support

Effect_20180117_194059.jpg
  1. Glue the remaining 1/2 length craft sticks together in a stack. Try to keep them as even as you can.
  2. Glue the stack to one 3/4 length craft sick. Make sure they are in the middle of the longer stick and there is room on each side.

Put on Upper Support

KIMG0983.jpg
Effect_20180117_194218.jpg
  1. Glue the stack of supports to the uprights about 1 to 1 1/2 inches down from the top.
  2. Glue the last 3/4 length stick to the other side of the uprights.

Start the Hinge

KIMG0990.jpg
Effect_20180117_194342.jpg
  1. Put the bottom of the box into the lid.
  2. Tear of a piece of Duct Tape about 3 inches long and sick the jumbo craft stick in the middle of the strip.
  3. Cut along the sides of the sick making a flap with the tape on each side.
  4. Tape the stick to the bottom of the box, allowing sick to hang off. The jumbo craft stick should be able to stand perpendicular to the box when lifted.

Make the Other Side of the Hinge

Effect_20180117_194429.jpg
  1. Prepare another piece of tape to make a hinge.
  2. With the jumbo craft stick upright, attach the hinge to the box. The craft sick should now be able to freely lay down and stand up.

Attach the Basket

Effect_20180117_194552.jpg

Glue the condiment cup to the end of the jumbo craft stick.

Finishing Steps

KIMG1012.jpg
Effect_20180117_194731.jpg
  1. Stand up the jumbo craft stick and lean it against the supports.
  2. Attach the rubber band. It should loop over the uprights and behind the jumbo craft stick and basket.
  3. Lift the box and store your ammo.

Ready, Set, Fire

KIMG1027.jpg

Put your ammo in the basket, pull back on the jumbo craft stick, and let it go. If the rubber band is too loose and you'd like more power, wrap it around the uprights to tighten the band.