Desk Lamp

https://makerworld.com/en/models/183681#profileId-202543

A 3D printer - to print the parts

BAMBULABS LED KIT 001 for this project.

https://us.store.bambulab.com/products/led-lamp-kit-001

3D Print The Necessary Parts

Run the USB cable in the the center of the light base holder, then press the light into the base to secure it.

Run the cable through the main base of the lamp out the square hole.

Using the plug, cap off the wire into the main base

Connect the DIFFUSSER by laying it on the LIGHT MOUNT ( super glue can be used to make to permanent)