Decorative K'NEX Toothbrush Holder With Rotating Display Stand

Here is my latest project: a decorative K'NEX toothbrush holder with a rotating display stand, powered by a Tethered Power Pack Motor. It can hold up to four toothbrushes, is very simple to make, and (in my opinion) looks very nice. It also includes a piece count. (see Step 1) I hope you enjoy making and using this! Below is a video of this project.

(Note: This is a parts list for both the Toothbrush Holder and the Rotating Display Stand)

Parts List:

Green Rods: 70

White Rods: 68

Blue Rods: 9

Yellow Rods: 16

Yellow Connectors: 8

Red Connectors: 16

Purple/Grey 1-Slot Connectors: 4

Orange Connectors: 9

White Connectors: 7

Purple/Grey 3-D Connectors: 32

Tan Clips: 2

Black Snap Cap: 1

Blue Spacers: 2

Gray Wheel Hub/Pulley- 2in: 1

Black Tire- 3 1/2in: 1

Tethered Power Pack Motor: 1

#32 Rubber Band: 1

Total Pieces: 247

Here, we will be making the Toothbrush Holder itself. Pay close attention to the image notes, and if you need any additional help, please contact me.

Now, we will make the Rotating Display Stand. Again, pay close attention to the image notes, and if you need any additional help, please contact me.

Now you are finished! If you post a picture of your finished Toothbrush Holder and Rotating Display Stand, I will put it here. Have fun!