DYI Hanging Phone Case

by Valletta Design Cluster in Craft > Reuse

2927 Views, 38 Favorites, 0 Comments

DYI Hanging Phone Case

P1480764.JPG
P1480768.JPG

Phone case (when charging)

DIY tutorial

Materials:

  1. Shampoo/Conditioner plastic bottle
  2. Cutting mat
  3. Scissors + craft knife
  4. Permanent marker

1a.JPG
1b.JPG

Let’s start with preparing an empty hair conditioner/shampoo container or even an empty water bottle (at least 1 litre). The size of the package depends on how big your phone is. Make sure it is well rinsed and dried.

2.JPG

Then, we need to remove any labels.

3a.JPG
3b.JPG
3c.JPG

When the container or bottle is free of labelling, we will mark the shape of our phone case. At this point, it is important to check the height of the phone so that the holder will be neither too shallow nor too deep. Once you do it, look at the photo below and start marking the suggested shape using a permanent marker.

4a.JPG
4b.JPG
4c.JPG
4d.JPG
4e.JPG
4f.JPG
4g.JPG

Finally, we can start cutting out our case. To do so, hold the container firmly, place the screw eye hook in the middle of the container, exactly in the centre of the marked line and push the screw in. Rotate the screw several times to widen the hole. Insert the craft knife in the hole we just made and start cutting along the line.

5a.JPG
5b.JPG

You can amend the shape of your case using a permanent marker and straighten the edges with scissors if necessary.

6a.JPG
6b.JPG
6c.JPG
6d.JPG
6e.JPG
6f.JPG

Our phone case is almost ready, now let’s cut out a hole at the top so that we can hang it on the charger while connected to the socket. As we did before, check the size of the charger, mark the shape with a marker (leave at least 1-centimetre distance from the edge) use the screw to make a hole and then cut it out with a craft knife.

P1480123.JPG
P1480125.JPG
P1480129.JPG

The phone case is now ready! You can decorate it using a spray but if you don’t have one, decorate it with duct tape, marker or a piece of fabric! Be creative and have fun!

P1480258.JPG

Quick tip if you are going to use a spray. Do it outside, place a piece of cardboard under the phone case, check the direction of the wind and patiently let one side dry for at least four hours after spraying, then spray the other side.