DIY: Leather Stitching Wheel

by desertsniper in Craft > Leather

23607 Views, 209 Favorites, 0 Comments

DIY: Leather Stitching Wheel

Picture 024.jpg
Picture 050.jpg
Picture 023.jpg
Picture 020.jpg
I came up with this idea when I was not really happy with my leather stitching. I looked around for stitching wheels and being cheap and resourceful, I decided to build my own! This project took around 2 hours and was from mostly recycled materials. Enjoy!

MATERIALS

chunk of wood
3/8" aluminum tube
1/4" aluminum tube
1/8" brass rod
star lock washer
2 part epoxy
your choice of wood finish
JB weld

TOOLS

hammer
hacksaw
band saw
small files
drill/ drill press
belt sander
sand paper
3/8" drill bit
1/8" drill bit

Materials

Picture 047.jpg
Picture 045.jpg
Picture 040.jpg
Gather your materials and check for good fitting between your star washer and aluminum tube.

Making Your Cuts

Picture 049.jpg
Picture 048.jpg
Picture 046.jpg
Safety first! Make sure you are using the proper safety gear for the tools mentioned.

Now, measure how much room you need to make the star washer fit in the aluminum tube. Mine was around 1/8"

cut you wood to length

trim the 1/4" aluminum tube to fit in the 3/8" aluminum tube

Drilling and Deburr

Picture 035.jpg
Picture 044.jpg
Picture 043.jpg
Picture 042.jpg
Picture 041.jpg
. Now that the slot is cut you need to drill the 1/8" hole for the brass rod to fit in and the 3/8" hole in the wood.

Take the file and straighten the cut up and remove any burrs on the 3/8" aluminum rod.

Shaping the Wood and Aluminum Rod

Picture 031.jpg
Picture 030.jpg
Picture 039.jpg
Using a belt sander, round off the 3/8" aluminum rod and deburr

Then, shape the wood, I shaped mine to comfortably fit my hand

Completing the Lower Part

Picture 038.jpg
Picture 037.jpg
Picture 036.jpg
Picture 034.jpg
Picture 029.jpg
Using JB weld steel stik secure the star washer to the 1/4" aluminum rod. This should be a snug fit.

Allow time to dry, then cut the brass rod to length, insert the rod through the recently completed star washer assembly and 3/8" aluminum rod and peen brass rod. Check to make sure the brass is properly peened and uses a belt sander to remove any extra brass.

Then trim the 3/8" aluminum tube so that it will properly fit in your handle.

Check to ensure it fits in the handle.

Finish the Wood

Picture 028.jpg
Using the finish of your choice, finish that handle.

Epoxy the Two Together

Picture 027.jpg
Using a two part epoxy (or other strong glue) attatch the 2 parts.

Allow time to dry

The Completed Tool & Thoughts

Picture 050.jpg
Picture 025.jpg
Picture 026.jpg
Picture 021.jpg
Picture 022.jpg
Picture 019.jpg
Congratulations! You just made a fine leather working tool!

This turned out great and I will likely make a few more.
However, the two main complaints I have about this tool.

1. The wood I used for the handle was still green and did not take to the stain well. (Still functions and looks good though)

2. The spacing on the star wheel is a little tight; I might trim every other prong.

Overall I really love this new tool and i'm sure it will serve me well for many years!