DIY Stomp Rockets

by Emsaid in Outside > Rockets

120136 Views, 107 Favorites, 0 Comments

DIY Stomp Rockets

SDC10068.JPG
SDC10037.JPG

In this instructable I will show you how to make stomp rockets out of house hold materials. I first saw how to make these a while back in a class when we learned about how rockets worked, I did tweak the design a bit, so this isn't quite designed by me. however, these do do a great job of explaining how rockets work and are great for class activities for students young and old.

You'll Need:

-paper
-tape
-scissors
-2 liter soda bottle
-1in wide bike tube( at least 3 ft long)
-1in wide pvc, abs pipe (at least a foot long)
-pen or pencil

Downloads

The Launching System

SDC10038.JPG
SDC10039.JPG
SDC10040.JPG
To make the launching system stretch the bike tube over the 2 liter soda bottle and add some tape if it doesnt seal well enough, then attach the other end of the bike tube to the pvc pipe and add tape if needed, now the launching system is done, so now we need to make a rocket.

Making the Rocket Body

SDC10041.JPG
SDC10042.JPG
SDC10044.JPG
SDC10045.JPG
Yo make the body of the rocket start with a piece of paper and roll it up longways and place it over the pvc pipe, before you tape it make sure it can easily slide on and off of the pipe, if its to tight it wont come off, to loose and and wont go as high. So once its at the right diameter tape it down the entire rocket to seal it better. Try experimenting with different diameter rockets and see if a tighter tube works better than a looser tube.

Add the Nose Cone

SDC10046.JPG
SDC10049.JPG
SDC10050.JPG
SDC10051.JPG
SDC10052.JPG
Now to make a nose cone I started out with a triangle shape piece of paper which work really well, but it doesnt really matter how you make as long as it has a cone. Once you have your paper cone taped place it on top of your rocket body, most likely there will be some "edge" sticking out, just cut this off and tape it on. now you need fins...

Making the Fins

SDC10053.JPG
SDC10054.JPG
SDC10055.JPG
SDC10056.JPG
SDC10057.JPG
SDC10058.JPG
SDC10059.JPG
SDC10060.JPG
SDC10061.JPG
SDC10063.JPG
SDC10067.JPG
To make the fins fold a piece of paper four time and draw a fin design, theres no correct way to draw them so you can make them how ever you want. To attach them stick a piece of tape to one side and place it one the rocket wherever you want then add a second piece of tape to the other side, repeat this step with the rest of the fins.

Launching!

SDC10068.JPG
SDC10067.JPG
145_0004.JPG
To launch the rocket, slide the rocket onto the pvc pipe and hold it pointing up (or at your desired target/person) and stomp on the 2 liter soda bottle, the harder you stomp the higher the rocket will go. after a while you may have to replace the bottle because sometimes it splits open, and you may also have to reinforce the nose cone, after a while it gets smashed in too.

Ask if you have any questions

Enjoy!

Downloads