DIY Simple Hot Gluegun

HERE is a coool ......simple......hot gluegun

I will say you about how it works...?

I used heating element of mosquito vaporizer as a melter for hotglue

I choosed good knight active plus vaporizer

• mosquito vaporizer heating element
• pvc pipe
• small piece of aluminium sheet
• wires
• screws
• flexible aluminium wire (image sown above)
• cardboard sheet
• furniture bush
• etc

• insert heating element in PVC pipe
• connect wires
• tight element with screws to the body
• turn aluminuim sheet like a con
• And solder joint
• Then attach it to heating element
• take a PVC pipe correct to diameter of hole of heating element

NOW its time to attach switch

• the best way is to take the vaporizer's switch
• I took that
• Attach switch by making hole on body

NEXT is to make a handle,

For that make a hole

For handle ;

• insert screw in the handle hole
• insert a bush (like above)
• take a card board
• cut it as a circle in diameter correct to of handle pvc pipe

next step to prepare handle,

• take a pvc pipe
• cut it a 20degree slanted position
• take another cardboard
• And cover pvc pipe

1. Attach handle to body with screw
2. take thick wire and bend it like a stand
3. attach it to body by making hole
4. Then glue gun look like this.......

1. take a Cardboard piece
2. cover backside of hot gluegun like pic above

FINISH the project.....

OUR SIMPLE HOT GLUEGUN IS READY...........

thank you.....

this is my first instructable...