DIY Shoe Stand
Making from Trash to treasure :-
It is a DIY shoe stand
Needed components:-
1) Waste oil cans 900ml = 6 nos
2) waste plastic plates (or) doors= (L x B) 400mm x 300mm
3) Bolts and Nuts (M6) = 10nos
Drill the Cap and Board
You just take the all oil can caps and drill using M6 drill bit.
*) 4 oil can caps you should be drill
and bottom of the oil can, you have to drill same M6 holes
*) And, We have to drill in side of the oil can for 2 cans for Base of the stand.
Drill the Plate
Please take the plastic plate and hold it in clamp .
>< Mark the center point of the 4 holes using above dimension.
>< Drill the Plastic plate using M6 drill bit
Assemble It
You just simply assemble that oil cans and plates using M6 bolts and nuts like above picture.