DIY Nebulizer Design That Is Affordable NO DRILLING

Using off-the-shelf parts to create a low-cost, DIY respiratory nebulizer.

I put together this device that can deliver aerosolized medication. There is NO DRILLING NEEDED which means any one can make this nebulizer.

There are only 2 key parts. A essential oil ultrasonic diffuser (GuruNadna bought on Amazon $18 USD) and a 7/16 O.D. clear tubing about 7 inches long (Bought at Ace Hardware $1 USD).

Cut the tubing down to about 7 inches. Clean and disinfect the tubing in warm soapy water and dry. Press one end of the tubing into the exit hole of the diffuser. The tubing will be your mouth piece when nebulizing.

Cleaning your nebulizer: Always make sure your nebulizer chamber is clean. Use 70% Rubbing Alcohol and a Paper Towel to clean the chamber and disinfect device between uses.

Nebulizing Inhalant:

I am using Ionic Colloidal Silver 10ppm as a anti-microbial.

Other recipes are distilled water with essential oils like tea tree, eucalyptus, pine needle, oregano, thyme, peppermint are all good choices and have been used since before the 1900's as inhalants to treat lung disease's.