DIY Jumper Wire Male to Male

In this instructable, we will make a diy jumper wire male to male. These types of jumper wires found application in arduino prototyping and breadboard prototyping.

The plus point of this diy jumper wire is that you can use a thicker or thinner wire as per your convenience.

1. Wire stripper
2. Male header (berg strip)
3. Ribbon wire
4. Heat shrink tube
5. Third hand (optional)
6. Soldering iron

First of all, take a single wire from ribbon cable. Strip it's ends using wire stripper. Apply flux so that soldering will be done smoothly.

Check out this video: