DIY Hot Wire Foam Cutter

Cheap and easy to build hot wire foam cutter made from common parts.
My version is made on 6v voltage. Power supply voltage depends on wire
used, its resistance and length. No problem can be built on 12v or other voltage.

Hot wire foam cutter

This is an updated version with PWM control

Hot wire foam cutter - Arduino PWM

• 1 x PVC pipe 3/4-in
• 1 x PVC tee 3/4-in
• 2 x 3/4-in 90-Degree PVC
• 2 x 3/4-in Copper Fitting
• Resistance wire
• 2 x screws
• 4 x nuts

For this project I need to cut the pvc tube in five parts.

• Pipe 1, 2 - 10cm
• Pipe 3, 4 - 8cm
• Pipe 5 - 20cm

I need to drill two holes. I use copper overlays, to pvc pipes do not overheat when working.

A very important thing is a spring that tension the wire.

Under the influence of temperature, the wire stretches.

That's why I used the spring.
All parts of PVC I glued with PVC glue.

You can use this tool to cut styrofoam, plastic and similar materials.

I even tested this tool for opening letters. Hot wire foam cutter is a very useful tool.

See also:
Hot Wire Foam Cutter - Arduino PWM