DIY Drill Guide

Hello~Friends

I made a drill guide a few weeks ago.

It can be horizontal drilling and vertical drilling, but also can be a mini disk sander.

Easy to make and useful.

I will show you how I make it.

My English is poor, Maybe watching the video will be more clear :)

No need for a bearing, cylinder rail, or any expensive hardware.

Just only plywood.

Tools:

1. Hole saw bit
2. Table saw
3. Router + dovetail router bit
4. Epoxy putty
5. Sandpaper

1. cut all plywood
2. Drill a hole that can hold the driller
3. the top plywood is the slider, sand it with sandpaper #400 or more to make it smooth

1. Combine all parts.
2. Make sure the slider will be slid smoothly, if too tight, adjust the screws.

adjust to 90 degrees and use epoxy putty to fix it

try out anything you want

1. Attach a disk and sandpaper
2. Make the trigger can push without a finger

If you like it, welcome to my Youtube channel to watch more.

Thanks for watching.