DIY Cute and Lively Big-Big Eyes Robot Toy for Kids

This instructable covers how to make lively and lovely big-big eyes robot toy to bring fun to kids and improve their hands-on ability. They are very easy to implement and no electronics knowledge requirements. OK, let’s go!

These are the materials:

4 x wheels

4 x rubber rings

3 x axles

3 x wooden blocks

2 x Eyes

2 x EPS foam ball

2 x cute eyes

2 x small rubber rings

2 x stickers

1 x AA batteries holder

1 x Motor

1 x fluffy line

Set the Rubber Rings Into the Wheels

Setting the rubber rings into the wheels is quite easy with just making a little effort.

Plug Z-shape Axles Into the Front Wheels

Plug the Z-shape axles into the front wheels just like the picture showing above.No direction required.

Use Knife to Slice EPS Foam Ball to Make a Flat Surface for Sticking the Eyes

Use Elmer's Washable No-Run School Glue to glue the eye to the EPS foam ball, or you can also prefer other brands of white craft glue. Scribble the glue to the eye pad and then gum it to the surface of foam ball. You can do the next step while letting the glue drying up.

Glue the Wooden Blocks As a Whole

Note that the side closer to the hole should be touched with the desk. It has been pointed out by red arrow in the picture above. You can do the next step while letting the glue drying up.

Fold the Fluffy Line and Twist

Fold the fluffy line in half and then twist like the picture shows above.

Make One Sticker Adhere to the Motor

Take the covering off then paste the sticker to the motor.

Make the Motor Adhere to the Wooden Frame

Make the motor adhere to the wooden frame like the picture showing above.

Make the Remaining Sticker Adhere to the Wooden Frame

Before pasting the stick to the surface of the wooden frame, you must make sure the sticker staying neat to the wooden frame.

Make the Batteries Holder Adhere to the Wooden Frame

Note that the direction of the power cable must be set like the picture showing above.

Install the Front Wheels

Plug the axles in both sides of motor.

Install the Rear Wheels and Fluffy Line

Pass the rear axle through the hole of rear wooden block. Turn the orange rubber rings onto the rear axle and then install the wheels. After that pass the fluffy line through the hole of the front the wooden block and make a twist like the picture showing above.

Attach the Eye Balls to the Fluffy Line

You can adjust the gesture of the eyes as you like.

Connect the Power Cable to the Motor

Well done!!!

For the Elmer's Washable No-Run School Glue you can get at https://www.amazon.com/dp/B00MAM0JL6

If you are outside the US you can buy other brands of white craft glue at the local supermarket around you.

For the components of this instructable you can get at https://www.mondaykids.com/big-big-eyes-reptile-insect-robot-for-kids-diy.html