DIY Creepy Halloween Orbs

DIY Instructions On How To Make A Creepy Halloween Decorations

Flip the light bulb upside down on a soft surface or prop it up with a role of tape like I did to reveal the light bulbs Electrical foot contact use the pliers to peel of the contact

Next use something sharp and narrow to pierce through the insulation layer and then use the needle nose pliers to fish the job in removing the insulation layer (Black Inner Rim Surrounding The EFC)

Use your flat head to break the filament by pressing firmly against it don't use to much force or it will break the entire bulb 

Use the needle nose pliers to remove the filament be sure to break as much glass as possible from the glass mount or it will be extremely difficult to remove

Simple wash the light bulb out with soap and water it will then take of the white coat making it clear

Poor your creepy blood or hummingbird feeder liquid into the bulb almost all the way to the top

Use a Magnet And two button cell batteries or other small batteries then but the positive lead on of the led on the positive terminal of the battery then but the negative on the negative side glue it together and tape it up make sure to super glue the leads of the led to make it water resistant

Simple PLace The LED into the Bulb and apply a lot of super glue and  make sure there are no gaps then wrap it in tape 

Place into the ground and you now have your creepy light bulb orb