DIY Covid-19 Test Booth. Part 2. How to Make an Adaptor to Connect the Booth to Gloves

The purpose of this instructions is to provide a solution to those interested to make a "phone booth" for Covid-19 test with commonly available materials.

One of the critical component is the adapter to connect the gloves to the holes on the booth.

This instruction is part 2 of DIY Covid-19 Test Booth.

There are a total of 5 parts.

Part 1. How to Make a Long Cuff (Sleeve) Latex Gloves From Two Short Gloves

Part 2. How to make an adapter to connect the Booth to gloves

Part 3. How to make a basic phone booth for Covid-19 test

Part 4. How to create a positive air pressure in the booth.

Part 5. Installing intercom system

1. Plastic pot (adapter)

2. Double sided tape

3. Cable tie 18 inch

4. Cutting tool (metal saw).

To remove the base, there are a few methods:

Option 1: Use a metal saw.

Option 2: Cut with red hot knife.

Apply double sided tape on the outer side of the pot. Then install the glove and install cable tie.

There are a few ways to install adapter on the round hole on the booth.

Option 1: Glue the adapter to hole from outside booth.

Option 2: Apply a ring and followed by option 1.

Here, for simplicity of this instruction, the acrylic was not presented.

Alternative:Glass is allow but extra care needed to sanding the glass holes. This is ti prevent potential injury in case medical worker scratch on sharp glass edge.