DIY || Blowable Electric Candle

Blowable Electric Candle is a candle which can be blown off and can reglow after sometime. The time after which it will reglow can be adjusted (by varying the capacitance).

This project is based on Transient clap switch circuit which is a circuit which turns ON the load (light) when it detects clap/blow. For this candle, the output effect of the circuit is reversed (using Relay) i.e. now the light turns OFF when it senses blow/clap.

To make this project, we require:

• Relay (6V)

• Condenser Microphone

• Transistors – BC 547 (2)

• Resistors – 330 Ω, 10 K Ω (2), 1 M Ω

• Capacitor – 4.7 μF

• Switch

• LED

• Battery (9V) and Battery Clip

• Wires

• PCB

• Cardboard

• Paper

Major Tools required:

• Soldering Iron and Solder Wire

• Hot Glue Gun

This circuit is basically Transient Clap Switch Circuit

You can refer these values to control the time for which the LED will be blown OFF.