DIY Arduino Laser-Tag Shoulders Module (Part.3 of 8)

Here is the stage.3 on building up the shoulders modules -- left and right.

Now you can build your own high -tech laser-tag system using Arduino, bringing the futuristic thrill of laser-tag Innovations kits - directly to you. This laser-tag system is a fully functional laser-tag set in kit-form, allowing you to build your own arena and gear.

The complete kit comes with all parts includes the following items (front, back, Phaser Gun parts and Shoulders 3D case, all Resistors, Transistors, I/R receiver diodes, I/R Tx diodes, Laser, Battery Charger, Cable and Body vest with cable and fixing plates attached for you. (plug & play)

Build your own DIY Laser-tag system “Great fun” Ideal for schools, clubs, and hobbyists

If you want to purchase a complete kit ( All parts supplied) or a Short-form kit (All PCBs components assemble and tested only) Also you can purchase any spare parts as well. Please Contact us.

Contact Information:

James

Email: ledxtreme27@gmail.com

David:

Email: inspectholdings@outlook.com

Assemble Stages

1. Front Pack build - Part.1
2. Back Pack build - Part.2
3. Shoulders Left/Right build - Part.3
4. Vest Assembly Part.4
5. Phaser Gun build - Part - 5
6. Battery Charger build - Part.6
7. Remote Electronic Score-Board build - Part.7
8. "New" Sentry Target Control build - Part.8 (In the Development stage)
9. "New" EMC Terminator Control Device build - Part.9 (In Development stage)

Note: The 7.4v lipo battery is not supplied with kit.

Laser-tag Phaser gun, before starting this project. Please check all parts against the ----- list below.

PHASER GUN PARTS ONLY

DESCRIPTION QTY

PCB Ver.W5A / W5B ---------------------------------- 2

330 Ohm Resistor ------------------------------------ 2

Case M3 Screws --------------------------------------- 4

8 Pin 2.54mm Connect Socket ------------------------ 2

5mm Super bright LEDs ------------------------------ 12

I/R Receiver Diode ------------------------------------ 3

Shoulder 3D Print Case Left / Right ------------------ 2

0.1uF Cap --------------------------------------------- 3

PCB Screws ------------------------------------------- 8

Insert and solder all the resistors to the PCB in the kit.

Insert and solder all mylar capacitors 0.1uf - (104) to PCB.

Bend the LEDs and then insert into PCB then solder --(Make sure LEDs are flush down on the PCB)

Insert and solder all I/R Sensors to PCB.

Insert the 8 pin sockets to the bottom of the PCB.

The finished shoulder PCBs, (Left / Right side) now ready for testing. Check that components are solder and inserted the correct way round (I/R receiver diodes, and 5mm LEDs.)

Do the same Assembly again for the other PCB that is supplied with this kit (Phaser Gun )