Cuztomize Your USB/Flashdrive
![instructables14.png](/proxy/?url=https://content.instructables.com/FIN/184L/I06J7AL4/FIN184LI06J7AL4.png&filename=instructables14.png)
When you buy a USB, don't you think others has the same? If so, try to personalize it with this instructable!
Take Out the Flashdrive
![instructables9.png](/proxy/?url=https://content.instructables.com/FHC/CM1B/I06J7AJL/FHCCM1BI06J7AJL.png&filename=instructables9.png)
If your Flashdrive has a rubber casing, pull it off. If it has a hard case, squeeze the casing with pliers until there is a hole on top.
Styrofoam
![instructables10.png](/proxy/?url=https://content.instructables.com/F60/UTL3/I06J7AJW/F60UTL3I06J7AJW.png&filename=instructables10.png)
The USB should look like this. Take your styrofoam.
Measuring
![instructables11.png](/proxy/?url=https://content.instructables.com/FW5/R3RA/I06J7AJZ/FW5R3RAI06J7AJZ.png&filename=instructables11.png)
Measure your desired size or shape as long as the USB fits in it. Make also for a cover. Just make sure you cut it neatly.
Scrape
![instructables12.png](/proxy/?url=https://content.instructables.com/F03/L4CB/I06J7AKI/F03L4CBI06J7AKI.png&filename=instructables12.png)
Using a small knife or a sharp stick, scrape a deep hole in the foam. Make sure to fit the USB constantly to get the exact deepness, width and height. Do the same with the cover.
Transfer
![instructables13.png](/proxy/?url=https://content.instructables.com/FL7/9RH8/I06J7AKP/FL79RH8I06J7AKP.png&filename=instructables13.png)
Place the USB in.
NOTE: Wrap a layer of masking tape on the body and the bottom. Don't cover the part you'll plug.
Personalize
![instructables14.png](/proxy/?url=https://content.instructables.com/F2Q/R2PA/I06J7ARU/F2QR2PAI06J7ARU.png&filename=instructables14.png)
Personalize it! Place construction papers around it. Paint it. Color it! Do anything with it! THERE! Your new USB.