Customizable Pet Food/Water Bowl - Made With Tinkercad (super Simple)

I have had a cat named Wild for 2 years now and I have always liked designing 3d models and showing them to my family so when I discovered Instructables I knew I had to mix the three together so I came up with this: I call it the Ultra simple Tinkercad bowl. I hope you enjoy it!!!!!!!!!!

-Tinkercad 3D design softwere

-Open Tinkercad and create a new project. Grab a cube from the shape selector at the right of the screen and place it in the middle of the workplace

-Select the square by clicking it and change its radius to 4.25 by looking at the options tab (at the right of the cube) and changing the radius to 4.25

-Select the cube and made both of its sides 150mm (15 cm)

-Select the cube and change its height to 5mm

-Select a half sphere and place it in the middle of the square

-Select it and make both of its sides 145mm (14.5 cm)

-Select both figures by holding shift and pressing them and in the top bar select the tool align and press the 2 buttons indicated

-Select the circle and set its hight to 47mm

-Grab a cylinder and place it on the workplane and set its sides to 90mm each. Align it in the middle of de figure using the same step as in step 7

-Select the cylinder and using the same tab as in step 2 make it a hole

-Select all of the figures and use the group option to grout them

-Drag some text to the workplane and align it in the middle or the bowl

-You can customize the text by entering it in the marked spot

-To finish here are some customization ideas.

HOPE YOU ENJOYED!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!