Credit Card Holder on Tinkercad

This is how to make a credit card holder using Tinkercad.

The link is here: https://www.tinkercad.com/

You need:

1. Internet access

2. Tinkercad

Get a box out and resize it to a certain size. I resized it to 25 mm by 40 mm by 5 mm.

Get a box hole and a cylinder hole out.

Resize the cylinder hole to 5 mm by 5 mm or less, and align to the middle of the solid box.

With the box hole, resize the thickness to about 1 mm and raise it so it will be approximately in the center in height of the solid box.

Put the box hole in the solid box, put half widthwise in the solid box, and resize the length so it's bigger than the solid box.

Make any adjustments to the pieces before grouping. I resized the cylinder hole widthwise to 7.5 mm. Then group. Then resize if you want. I resized it lengthwise to 50 mm.

If red is not what you're going for, change the color. I changed the color to black.