Corner Bracket V1

This is a corner bracket made to connect to things at a 90 degree angle joint. More info or if u want to support me at https://www.printables.com/model/1414334-corner-bracket-v1 or if want to boost me at https://makerworld.com/en/models/1833477-corner-bracket-v1. It is free.

-3d printer

-4 screws/nails

-hammer/screwdriver

I used Tinkercad for the design process. I decided to build off of what a normal joint would look like. Then I added support to the to wall-like of the 2 sides for more strength. Then 4 nail holes is made for a screw or nail. 2 works, but 4 is good if the bracket is too big for the situation in which it is needed.

1. Print out the corner bracket
2. nail or screw in to any joint where this is needed
3. the bracket stays and doesn't move