Concrtete Lamp

Hello People!! I used some empty bottles of milk and some concrete that was left, and i made this lampshade!

I hope you like it!

For this project i used

1. two empty bottles o f milk (one big and one smaller one),

2. a lamp

3. some concrete with water and sand

4. a wire

5. one smallpiece of 5 cm polysterine.

For the mold, i used the two empty bottles of milk.

First of all , i cut the bottoms of them both.

Then I tried to put the one inside the other, so there will be a gap about 2 to 3 cm everywhere.

I used plastic bottles of the same company, so the shapes of the big and the small bottle are almost the same.

After that, i mixed the concrete with water and sand, and put the mixture inside my mold.

I left the concrete there for one day, in order to be strong enough, so i could cut the plastic bottles.

After the mixture was strong enough, i removed the two bottles and i made a hole in the back of lampshade as shown in the picture.

After that i put the wire through the hole, and attached it to the lamp.

In order to keep the lamp stable inside the concrete lampshade, i attached to it a piece of polysterine as you can see.

After that the lampshade is ready, the next step is to choose some nice place that you need light and hang it