Computer Build 1 KCTC 2nd Session

You will need the following parts to complete your build:

1) Motherboard

2) CPU

3) Heat sink + Fan

4) RAM

5) Computer Case

6) Hard Drive

7) Power Supply

8) Graphics Card

Pull up the CPU lock down arm.

Align the CPU using the golden triangle.

Be careful not to force the CPU into the socket.

It should just drop in without any resistance.

Push down the CPU lock down arm.

Apply a rice sized dab of thermal paste in the center of the CPU.

Align the clips and lock down the heat sink.

Align the notch on the RAM module with the notch on the motherboard's DIMM slot.

Press down until you hear a click.

Install the standoffs to match your corresponding motherboard.

Install your I/O shield with the proper orientation.

Be careful not to cut yourself on the sharp edges.

Align the motherboard with the standoffs and put in the screws.

Align the graphics card and push it into the socket.

Add the screw for extra support.

Use the text on the motherboard to identify where you should plug in your USB and audio cables.

Follow the diagram provided by your motherboard manufacturer for the power, reset and led connections.

Align the power supply and insert the 4 screws at the back of the case.

Mount the hard drive.

Install the SATA data and power cables.

Connect the 24-pin and 4-pin cables to your motherboard.

Tuck away the rest of your unused cables.

Screw in the fan with the label facing the outside of the case.

Plug the chassis fan into the System_Fan_1 pins.

Admire your build!