Clay Water Fall (Recycled)

Turn your hat from a flat plane to a looping water fountain...

made with only recycled parts.

Materials used- Tools:

Utility Knife

Marker

Ruler

Protractor

Liquid Glue

Materials:

Clay

Styrofoam Sheets

Water pump

Vinyl tube/silicon rubber tube

For the pyramid mark the Styrofoam board with 3 inch, 2 inch , 1 inch squares on different parts of the board with the ruler and protractor and for the basin mark two 5 inch squares as for the pyramid. (As shown in the image)

Cut out all the parts and for one of the 5 inch board make a 4.5 inch hole in the center of the Styrofoam

1.Stick the 1,2,3 inch squares from biggest on the bottom to smallest on top leaving .5 inches on each side from each ascended cut outs.(As shown in image)

2. Stick the 5 inch board underneath the 5 inch with the hollow middle.

3.Let the glue dry.

1.Layer Clay over the pyramid and basin neatly so that the water won't seep through the holes on the Styrofoam. (and also to make it stand out (¬‿¬) )

2.Pass one vinyl tube through the middle of the pyramid and middle of the basin and one though the bottom of the basin.

(also clog all unwanted holes in the basin except the tube)

If you wish to move around with this creation, do sew it onto the hat so it does not fall off.

1.Connect the tubes to the water pump and power it then pour water into the basin or the pyramid ( don't put to much or when you take it for a spin it will get you all wet, I'm speaking from experience)

2.Enjoy