Charger Cord Organizer

Make a Sugru cord holder to organize your device charging cords and hold them in place. 

Materials: 

4 packs of Sugru (5g each)
Popsicle stick and plastic spoon (for molding and cleanup)
small piece of thin plastic (as a non-stick surface for molding the holder)

Use 2x 5g packs of Sugru for the base.

Flatten into slab for base, about 1/8” thick.

Note: this picture shows the base being molded on paper, but you will want to place it on the plastic.

Use 1x 5g pack of Sugru.

Roll into a cylinder shape, then flatten the cylinder into a rectangle.

Place the rectangle on the base. 

To form the comb, use a popsicle stick to make indentations in the rectangle to form the comb.

To make a perimeter for the base, take ¼ of a 5g Sugru pack and roll it into a long string.

Apply the string around the perimeter of the base.

Tidy the perimeter with a plastic spoon.

Allow 24 hours for holder to harden.

Enjoy!