Cell Phone Case Out of Knee Brace

by Fikjast Scott in Circuits > Mobile

1222 Views, 3 Favorites, 0 Comments

Cell Phone Case Out of Knee Brace

july 019 (Small).JPG

I made it at Techshop. http://www.techshop.ws/

 

 

I needed a cell phone case for my new phone.  I wanted something that stretched to phone shape and easily fits into my pocket.  I came up with the following.

Materials for Case

july 013 (Small).JPG

I purchased a stretchable knee support form a dollar store. Pulled out needle, scissors, needle threader and some matching thread.  This actually yields two cases.

Lay Out

july 015 (Small).JPG

Lay the phone for sizing.

Cut the Leg Brace

july 016 (Small).JPG

I cut the brace with household scissors about 1 inch past the side of the phone.  (I did not measure).

Sew the Cut End.

july 017 (Small).JPG

I do not know the name of the sewing stitch I used. I started about a ¼ inch from cut off end.  I pull my stitches tight, going over the cut end; spacing my stitching about ¼ apart.  Going from one side to the other and back again; I then knot it off and cut.

Turn It Inside Out

july 020 (Small).JPG

Turn it inside out and bingo a nice inexpensive cell phone case.