Cardbord Pinball Machene

have fun with your friends playing fully functiol pinball!

cardbord

Hot glue

Skewers

Rubber bands

cutout the exact size that you whant make it look kinda like the photo also start heating up your hot glue gun

however big your base is cut out the top the same sizeit should look like this

cut out 4 flipers each so 8 in total use 4. Use 3 for holes the last one has to be one with no holes at all it should look like this but make shure your back has 3 holes it should be about half a inch make 2

hot glue in skewers than put in top its as easy as that for this step!

tape down your flippers in position tha t you want than put on 3 cardbord pices all hot glued add the 4th one and it will not have holes make 2 make sure the piece is 3 and a halph inches long and 1 and one third inches for with hot glue all pices together and hot glue the piece onto the skewer as shown in the picture it should be sturdy

in this step you need too add a small pice that is a barier and than add a skewer on top The barier should have a opening at the to it should look like the picture

make 6 of the same size pushers make 3 per side and glue them together and put a skewer on the buttons it should look like the picture and it should have a button kind of thing than you need to put on rubberbands on both sides it should come back

add a skewer to both sides attaced to the fliper add a ruber band to those sides and if it does not come back proprly add a stabliser a small peice to make it come backmy problem just had to just make a barrier and i also fixed it with the rubber bands it should look like the picture

start of by cutting holes for the flippers in the base than make a cup thing and a hole for the ball to go into it should have a ramp add suppors and back board if needed for it after it should look like the picture

next you have to paint and make obsticals i dont have a picture but just make obsticals and paint it!!!