Cardboard & Denim Sticker Display

by elizabethwebb in Craft > Cardboard

216 Views, 5 Favorites, 0 Comments

Cardboard & Denim Sticker Display

20240512_220910.jpg
20240512_220703.jpg

Do you sell stickers at craft fairs or in a retail store? Do you need an inexpensive (read: basically free) way to display them? Then this is the instructable for you! All you need is some cardboard, some old jeans you can cut up, and a bunch of hot glue.

Supplies

20240512_111829.jpg

Here’s what you’ll need:

  1. lots of cardboard
  2. scissors
  3. an old pair of jeans
  4. a ruler
  5. a pencil
  6. a hot glue gun

Get Some Cardboard

20240512_112011.jpg
20240512_113143.jpg

Start drawing a staircase like shape onto the cardboard. Mine was 11” tall at its tallest, and 10” wide at its widest. Each of the four lower steps (where the stickers would sit) were an inch wide, and going up at approximately a 60 degree angle. The highest step was about 2” wide.

Cut Them Out

lv_0_20240529060636.gif
20240512_121053.jpg

Cut out the piece you drew and then cut out an exact copy, turning it over so they’re opposites.

then cut out the following rectangular pieces:

  1. four 1” x 10” strips (the steps)
  2. one 2” x 10” strip (the top)
  3. one 11” x 10” rectangle (the back)
  4. one 10” x 10” square (the bottom)
  5. four riser pieces (not shown - 10” x however tall your risers are)

Start Assembly

20240512_121542.jpg
20240512_121751.jpg

Using a lot of hot glue and cardboard “brackets” (small strips folded into 90 degree angles), assemble the sides to the back.

Continue Assembly

20240512_123427.jpg
20240512_130048.jpg
20240512_131015.jpg

Continue gluing and bracketing pieces, starting at the top and making your way to the bottom piece. If you want, you can cut a draw bridge style hole in the back for storage.

Cover

20240512_202002.jpg
20240512_203143.jpg
20240512_204511.jpg

You could technically stop at the previous step if you wanted, but if you want it to look a little more polished, feel free to continue with covering. Cut up some old jeans and, starting with the front of the steps, hot glue a large piece. Fold the excess over the sides, gluing it down as you go.

20240512_204706.jpg
20240512_205343.jpg
20240512_210118.jpg
20240512_210133.jpg
20240512_212329.jpg
20240512_220930.jpg

Find some thin cardboard, like a cereal box, and cut two pieces to the size of the sides. Cover with denim and glue to the sides. This way, no cardboard or raw edges of denim are left exposed. Cut rectangular pieces of cardboard to act as “lips” for each step, so whatever you’re displaying won’t slip past the edge. Cover them in denim and hot glue to the front of each step.

Finished

20240512_220815.jpg
20240512_220616.jpg

All that’s left to do now is display your stickers! I took mine to a store where I sell stickers and the owner loved it. And it barely cost me anything to make!