Card Box Toy Car Build

A battery powered toy car card box

4 Gatorade Caps

Hot Glue Gun

Scissors

Wires

Motor

Cardbox

Tape

Ruler

Chopsticks

Batteries

Straw

Soldering Gun

Cut the front of a card box with a scissors (start heating Hot Glue Gun)

Hot glue the caps to the Chopsticks for the front wheels ( make sure the chopsticks are in the middle of the caps)

Measure and cut both straws, one by 1.5 inches and the other by 2 inches.

Measure two sticks to 3.5 inches then cut them

Glue the straws to the front and back of the cardbox then put chop stick through the straws

Put the motor wheel through the chopsticks about half way

Put tape on the chopsticks to prevent from sliding through

Let the straw cool down and dry for 2 to 3 minutes before moving on

Hot glue the second chopsticks and put it in the middle of the cap

Put the Chopsticks through the straws and hot glue the chopsticks to the middle of the caps and let it cool for about 2-3 minutes

First with this step it is really important to be very careful because the Soldering gun is extremely hot and will burn you very badly! Before wiring the motor plug in the soldering gun and let it heat up (it takes about 5 Minutes to heat up) while you are waiting you can put the orange wheel on the motor. Then once the soldering gun is heated up you can start soldering the wires to the motor.

Grab the batteries and start to put hot glue on the back of them and then stick it to the card box. then let it cool for about 2-3minutes hold it while it is cooling.

Now you'll be getting the motor and putting hot glue on the back and the sides of the motor and then sticking it to the card box. Then hold it while it is cooling for about 2-3 minutes.

Put rubber band around the motor wheel on the chopstick and then connect that same rubber to the motor wheel on the motor and then you are finished. Now you have a working toy car that can ride around.