Carboard Soilder With Old Helmet

I made a cardboard solder to represent the helmet on those before fought in battle with. I also wanted to use this cardboard face and arm design as a helmet holder. Use whatever helmet you want and make sure it fits for what you are using. (Helmet was not made)

You need lots of cardboard, scissors, clear tape, and an old helmet. But most importantly, time.

Cut a long narrow piece and shape one end to resemble the face.

cut a piece with the width the same has the previous and cut on one end the resemblance of the back of a head.

Tape the two pieces together on the ends that are only cut flat.

Cut two pieces of cardboard that are identical and shape it to the side of the face.

draw whatever you want for the face, you can even add hair and on the sides of the face draw ears.

Tape everything, the face the sides of the face, and if you want it to look nice. Tape the whole thing to make it look nice and laminated.

As soon as you are done with the head put on whatever helmet you have and make sure you make the right measurements to fit the head in the helmet.

Cut out a decently good shape of what you think a hand looks like and snip the middle to make the fingers and thumb.

cut a rectangle and that is it.

put the arm overlapping the hand and tape it together.

create a cardboard stand and tape it to the arm. Then, create whatever design you want and apply it to the arm. For the purposes of building a cardboard solder, I made a camoufaged arm

You are finished, celebrate! This was the tutorial for the cardboard solder, farewell.

( This tutorial may not be perfect, after all, I am 13 years old.)