Capo Snap (Pick Holder for Any Capo)
by flowstyleliving in Living > Music
1391 Views, 18 Favorites, 0 Comments
Capo Snap (Pick Holder for Any Capo)
A holder for a single pick (ones that stamp out) that attaches to any capo
Tools:
- 3D printer
- Support remover tool (Pliers, hammer/chisel :)
Hardware:
- 8/32 x 5/16 small pattern nut
- 8/32 screw
- 8/32 wing nut
- Super glue
- Capo
Tools:
- 3D printer
- Support remover tool (Pliers, hammer/chisel :)
Hardware:
- 8/32 x 5/16 small pattern nut
- 8/32 screw
- 8/32 wing nut
- Super glue
- Capo
Print It!
:)
Remove Support
Best when freshly printed from my exp
CS Jaw:
Crunch out the stuff in the middle, remove the plate under the recessed nut feature, as well as by the fitting joint.
CS Body:
I found mallet to a precision screwdriver got out the overhang support quite well.
CS Jaw:
Crunch out the stuff in the middle, remove the plate under the recessed nut feature, as well as by the fitting joint.
CS Body:
I found mallet to a precision screwdriver got out the overhang support quite well.
Super Glue the Nut and Press In
Should sit tight and flush
Snap in the Body and Create Wing Nut Fastener
Super glue the wing nut and bolt/screw together
Super glue the body to the jaw if you see fit ;)
Super glue the body to the jaw if you see fit ;)
Ta-Da!
(+1 More Step):
Cut out a piece of credit card and place between the Capo and the Wing Fastener
Cut a piece of sandpaper or some sort of nonslip surface on the otherside of the Holder.
Cut a piece of sandpaper or some sort of nonslip surface on the otherside of the Holder.