Canon Remote Shutter From Car Charger

Hi there, Today I will share all of you to make DIY Canon Remote Shutter from Car Charger.

The Equipment needed is :

1. Old Car Charger
2. Solder
3. Relay Button
4. Adapter 2,5 mm

Open Car Charger

If you have old/used car charger do not throw it at garbage. You may make some DIY project like I did..
First Thing that you must open the car charger.. and cut the cable to small board, I used different picture of car charger to make it, cause i bought it just for almost 10.000 Rupiah (1 USD) for 4 Item.

Solder the Cable

After you opened, solder it to Relay Button which is I show u bellow. make sure you have the good soldering.

Put the Relay Into Casing

Try to put the relay button into car charger casing to have good handle when you pressed it. If you have a problem with the diameter relay button try to use hot iron to blend some of the plastic.. I did it... :)

Ooohhh.. sorry for ugly nails... do not fokus on it...

Solder to Another Plug End

Solder the end plug to the middle pin and the corner pin... pin between them ignore it. for further info please see the picture.

Adapter Use

if you don not have 2,5 mm plug you may uses the adapter for it, just I did

In Action

Plug the jack to shutter plug.. and ready to use.. you may halfpress to fokus the object and then full press to take a picture..

have a nice save and making portrait... if you think this instruction may be useful for your daily hobby, please vote for me..

Regards,
Muchlis