Candy Cane Twist Knot

by asemery in Outside > Knots

1467 Views, 4 Favorites, 0 Comments

Candy Cane Twist Knot

eric fry 036.JPG

This is a variation of the crown and wall lanyard.

https://www.instructables.com/id/Crown-and-Wall-La...

By adding a over two crown knot a spiral effect is achieved.

I used 2 cords of 1/4" diameter cord - 3 1/2" long

eric fry 001.JPG
eric fry 002.JPG

Arrange the two colors as shown

Tie a temporary seizing.

Tie another seizing a short distance to the right.

eric fry 003.JPG

Tie a crown knot immediately above this second seizing. Each strand goes over the strand to its right.

eric fry 004.JPG

Take any strand and bring it over one and under strand of contrasting color.

eric fry 005.JPG

Turn the knot towards you and bring next strand over one and under strand of contrasting color.

eric fry 006.JPG

Likewise with the third strand.

eric fry 007.JPG

And the fourth.

Over Two Crown Knot

eric fry 008.JPG

First tie a crown knot to the left (clockwise).

eric fry 010.JPG
eric fry 011.JPG

Now take any strand and bring it through the bight to its left.

eric fry 012.JPG
eric fry 013.JPG

Do the same with the next strand.

eric fry 014.JPG
eric fry 015.JPG

And the third.

eric fry 016.JPG
eric fry 017.JPG

And the fourth.

The knot is complete. On to the doubling process.

The Doubling Process

Untitled.png
eric fry 020.JPG

Each strand of the over two crown knot emerges adjacent to a strand of the same color.Take strand "A and follow its mate under one strand.

eric fry 021.JPG

Under one crossing the end of the knot.

eric fry 022.JPG

And under one strand.

eric fry 023.JPG
eric fry 024.JPG
eric fry 025.JPG

Do the same with the next cord.

eric fry 026.JPG

And the third and fourth cords.

The knot is almost complete. All that remains is to pull the cords through the knot.

eric fry 027.JPG
eric fry 028.JPG

With a forceps grab any end (in this case white) and pull it through the knot..

eric fry 029.JPG
eric fry 030.JPG

Do0 the same with the next strand (grey)

eric fry 031.JPG

Likewise with the remaining strands. Now begin to remove the excess slack from the knot.

loop.png
eric fry 033.JPG
eric fry 034.JPG

When the knot is fairly tight you will want to make the white loop at the left of the knot disappear.

Take strand "A" and pull until the loop vanishes into the knot. Then complete the tightening process.

eric fry 036.JPG

For the large knot on the left I added a second set of over under knots before going to the over two crown knot (step 7)

For the red and yellow knot I did not make any over under passes but went directly from step 2 to step 7.