CPB Jar of Light

This is a magical 3D printed jar of RGB lights that simulates real fluid behavior

First fold the tin foil into the above shape to create 4 contact points

Find four rectangular holes in the 3d printed jar and use glue gun to install four metal contacts, the inside should look like this when finished

cut out a piece of rectangular sheet of foam and install it in the inside of the 3D printed jar wall

wrap the 8x32 RGB pixel grid around and place it inside the jar

Use wire stripping tools to prepare the connector wires for the RGB LED matrix

- Connect RGB matrix connectors to the CPB (A1 pin)

- Connect alligator clips like in the picture (A4, A5, A6, 3.3v pins)

- Connect battery pack to the CPB

connect alligator clips to the tin connectors at the bottom of the jar

Put all electronics and wirings inside the jar (note the orientation of the CPB)

Close the lid and complete the build, now we will need to create another same jar again

Choose one jar and upload this program to the PCB on it

Upload this program for the PCB on the other jar

Layout tinfoils on a piece of cardboard like this

- cut holes for the water faucet on another piece of cardboard,

- install the water faucet

- and finally put everything together