CONTROL a 7 SEGMENT DISPLAY

All you need is

Momentary switch

2(or more) 7 segment displays

Jumper wires

And a breadboard/ 3.5 power supply!



__________________________________


Also the diagram is just for the "COM" pin that is connected to the GND on the breadboard.

First connect all the negative pins to a row on the board,

Then get another wire and connect it to the switch.

Now take a few wires and connect the positive to 1 of the pins on the display so something turns on,

Now trial and fail until you get the digital you want!

Now you are done and if you wired it right it will light up!