CIRCUIT OF OBSTACLE AVOIDING ROBOT USING TINKER CAD

so we are going to see how to create circuit of obstacle avoiding robot

This is a Simple Obstacle Avoiding Virtual Circuit built using the TINKERCAD Simulation. In this project our Virtual Circuit is programmed to turn in left directin when the distance between robot and obstacle decreases to 10 cm or else it will continue its path.

The Following are the components required to make circuit.

• Bread board - 1
• L293D (Motor Driver) - 1
• DC Motors - 2
• Arduino UNO - 1
• Ultrasonic sensor - 1

Make the following connections as shown above.

Finally Assemble thce codeblocks as shown using the tinkerCad Simulaton Enveroinment.