CAD a D6
![D6.PNG](/proxy/?url=https://content.instructables.com/FF7/08NE/L4E6GKQH/FF708NEL4E6GKQH.png&filename=D6.PNG)
Supplies
CAD Software, I use OnShape as it is free
Base Square
![Base.PNG](/proxy/?url=https://content.instructables.com/FYH/JGI3/L4E6GKRO/FYHJGI3L4E6GKRO.png&filename=Base.PNG)
- Make a Square whose center is on the origin and the points are on the axis of the other planes
- Add your one dimension to say how big the square is
- Add a construction line from the constrained point down along the "Right" plane
- Make the construction line be equal (same length as) the side of the square
Find the Center of the Cube
![Center.PNG](/proxy/?url=https://content.instructables.com/FDR/GMMI/L4E6GKSM/FDRGMMIL4E6GKSM.png&filename=Center.PNG)
- Use the construction line from the previous step to make a construction circle
- Make a (construction) center point rectangle
- Connect the bottom 2 points to the edges of your square
- Connect a top point to the circle
- The center of the rectangle is the middle of the cube
Loft to the Center
![Loft.PNG](/proxy/?url=https://content.instructables.com/FC1/01O6/L4E6GKZH/FC101O6L4E6GKZH.png&filename=Loft.PNG)
- Loft to the center point you just found
Mirror the Loft
![Mirror.PNG](/proxy/?url=https://content.instructables.com/FDO/F9TK/L4E6GL1U/FDOF9TKL4E6GL1U.png&filename=Mirror.PNG)
- Mirror the parts about the triangular faces until you have a cube
Finish!
![D6.PNG](/proxy/?url=https://content.instructables.com/FN8/LF5W/L4E6GL4T/FN8LF5WL4E6GL4T.png&filename=D6.PNG)
You now have a "blank" D6!
Feel free to add numbers to it or whatever else you want!