Bullseye Archery Award

I created a trophy that includes an arrow piercing through a bullseye.
Supplies

I used CAD OnShape to create my trophy.
Create Target


Sketch four center point circles with 2 inches, 1.5, 1.0, and 0.5 diameters. Then extrude them with 0.5 in, and color them differently.
Create Arrow




Make a sketch on the right plane and create a line from the origin to 3 inches out. Then create a sketch on the front plane where you create a center point circle at the origin with 0.125 in diameter. Then use the sweep tool to extrude the arrow created. Click on the line pointing out and the center point circle with the sweep tool. Then use mirror tool to create the other half of the arrow.
Create Arrow Details





Create a sketch on the face of the sweep, then create a center point rectangle of 0.15 by 0.15. Then extrude this rectangle to 0.25 in. To add detail and sharpness to the arrow, use the chamfer tool on the edges of the extruded rectangle. Then on the back of the arrow, create a sketch on the face of the arrow and create three triangles. Next, extrude the traingles to 0.125 inches back towards the arrow.
Creating Trophy Base





Create a new plane, then select the top plane and drag the new plane you made 1 inch down. Now, create a sketch on the newly made plane with a center point rectangle at the origin that measures 2.5 inches by 1 inch. Then extrude your sketch downwards and make the extrude 0.5 inches. Then create a sketch on the face of the trophy base and write out "1ST PLACE ARCHERY AWARD". Then extrude remove it by 0.25 inches. Now you are done :)