Bubble Gum USB/Jump Drive Case.

this is how to make a custom USB/Jump Drive skin so no one will
know that you have a USB/Jump Drive.

What you will need.

1) pack of gum
2) USB
3)Glue
4)cardboard

you can use any USB/Jump Drive; First, you must remove the plastic housing that surrounds the USB/Jump Drive. As long as you're careful while removing the housing, it won't affect the performance of the USB/Jump Drive.

You need to unwrap the gum carefully(Along the seams) to keep the paper neat. Unfolding it along the seams allows you to get your USB/Jump Drive in it, while keeping it looking authentic.

Next place the USB/Jump Drive in the opened gum wrapper. It should fit snugly so it won't slide around, but you don't want the wrapper to be formed around the USB/Jump Drive-you want it to look like an actual pack of gum.

After putting the USB/Jump Drive in the gum wrapper, you may decide to add a piece of cardboard in the pack to make it more rigid. This is optional.

Next, cut the top of the gum wrapper to create a cap that you can take on and off to use the USB/Jump Drive.
To make the fit tight and rigid, add cardboard spacers inside of it.

Next, glue it all together and leave it to set overnight

Now you're done! It should look like a pack of gum, if you've followed all of the directions.
Thanks for making it!