Broad Head Arrow From Aluminum Foil

by seanmarsh in Workshop > Metalworking

1703 Views, 6 Favorites, 0 Comments

Broad Head Arrow From Aluminum Foil

20180503_120430.jpg

This Instructable will show you how to turn a simple roll of kitchen foil into a broad head arrow.
There is no need for a forge, as a simple kitchen gas hob or a BBQ is all that is required.

Kitchen Foil

20180408_102109.jpg

The key to using kitchen foil to create an aluminium blank is to remove the cardboard roll from the center. Using long nose pliers grip the cardboard roll in the center and pull out. You may need to do this a couple of times to fully remove the cardboard. Don't worry if you pull out a bit of foil too.

Heat and Tap

20180408_111413.jpg
20180408_112627.jpg
20180408_112632.jpg

Keep tapping the round roll with a hammer until it's flat.
Heat sections of the foil until almost glowing then repeatedly tap flat with the hammer.

Repeat this until the foil changes from a roll of foil to a blank of aluminum. This can be tested by tapping the cool blank on the hammer head. It should sound like a piece of metal when it's done (a ting noise rather than a donk noise).

Keep Tapping

20180423_124840.jpg
20180423_124851.jpg
20180423_124842.jpg
20180423_124907.jpg
20180423_124911.jpg

Keep tapping like you are a black smith, as this will harden the foil blank even more.
Don't worry about hammer marks. The blank should now feel like a solid bit of metal.

Cutting

20180425_134616.jpg
20180501_133911.jpg

Cut of a section about 4" or 10 Cm long

Shaping

20180501_135251.jpg
20180501_140214.jpg

Using a marker draw the arrow head shape on the blank.
Carefully cut the arrow head to shape

Making and Edge

20180501_140337.jpg
20180501_141928.jpg

Carefully sharpen the edge of the newly cut arrow head.
I use wet stones that I have bought online.

Putting the Head on the Shaft

20180503_114554.jpg
20180503_115140.jpg
20180503_115449.jpg

I used an 18" or 0.5 meter dowel for the arrow shaft.
Sawing down the center of one end just long enough for the shaft of the arrow head.
Then, using garden string, the shaft was wrapped tightly to secure the arrow head

Duct Tape Fetching ​

20180503_115719.jpg
20180503_115802.jpg
20180503_115900.jpg
20180503_120440.jpg
20180503_120111.jpg

Cut a section of duct tape and fold it over so it joins together, leaving the edge section unfolded so that it's still sticky. This is the bit that will stick to the dowel (arrow shaft).
Repeat twice more (three in total) and attach to the shaft.

Trim the front edges of the duct tape from square to a 45 degree angle and the arrow is complete.

Shooting

20180503_120426.jpg
20180504_192651.jpg
20180504_192708.jpg

The arrow was shot into a sandbag.
As you can see the arrow went far enough to be a useful weapon and in the third image the head was totally undamaged. Meaning that you can make a usable broad head arrow from kitchen foil...