Robotic Gear Arm Could Be Used for 3d Printing

by ofer9430 in Circuits > Arduino

1950 Views, 4 Favorites, 0 Comments

Robotic Gear Arm Could Be Used for 3d Printing

armmodelo1.jpg

The goal I wanted to give the robot

It is to make a model and demonstrate the force of its force transfer system through gears and with this also generate touch.

Ball bearings are used to reduce friction and make the robot move more harmoniously. The robot is designed to have a low center of mass.

A tx source was tapped to provide a 12v and 5v power supply for the motors and plate respectively

​hardware

armmodelo2.jpg

The control system uses an Arduino Mega with a RAMPS 1.4 board and A4988 drivers. I provide a solid and functional programming foundation for the Arduino, which handles the interpolation of the stepper motors, performing all the geometric calculations, and smooth accelerations. It can handle some kind of serial GCODE communication.

Turntable

placa base.jpg

Turntable

It has a bearing so that the stepper motor can be actuated and the flexibility of the arm can be controlled as a step.

The fully extended robot arm at the top multiplies every gear and bearing tolerance it has.

Basearm3.jpg

It is this part of genera and carries mechanical energy

It is composed of the impreza parts (h, locks), bolts, stepper motors and gears.

Acoplamiento De Motores

motores peq.jpg

It is this part of genera and carries mechanical energy

It is composed of the impreza parts (h, locks), bolts, stepper motors and gears.

Base With Roller Bearing Gives Degrees of Freedom of Rotation

Basearm0.jpg
Basearm2.jpg

Mechanical System Name

Armdesarmado.jpg
prensa1.jpg

for arm (coupling of bearings preferably to place them using a press, I use a small press against a table they are not very expensive in hardware stores these 3 or 5 dollars)

Motor and Electronics

pap.jpg
fuente y arduino.jpg

Nema 17 motors of 0.6 were used, which gives you the precision unlike servos, an Arduino mega and a 1.4 ramp with its 4988 driver to control the motors and a tx source you can take out of an old computer and bridge the cable green with a black one so that the source turns on every time you feed it with AC

Body

todo.png

Piezas Stl

here is all the stl so you can print it on your 3d printer

Codigo

code

Downloads