Bottle Opener and Lime Slicer in One

Pop open your favorite beer and slice your lime with one tool.

Instructions to use it:
STEP 1 – Open the bottle.
STEP 2 -  Slice your lime.
STEP 3 – Enjoy!

Instructions to make it:
STEP 1 : You need a steel strap that is about .125” thick.
STEP 2 : Using the horizontal band saw cut the steel strap 1.25” x 6”
STEP 3 : At this point you have a piece of steel that is 6” long and 1.25” wide.
Lay it down horizontally and measure 1.25” from the left side and about .625” from top to bottom and mark a dot there.
STEP 4 – Make a half inch tap with the drill press using a ½” bit.
STEP 5 – Measure 3” from the left side at the bottom and trace a line to the upper edge of the hole and using the vertical band saw make a cut.  Make another cut vertically from the lower edge of the hole to the bottom of the metal.
STEP 6 – Using a disk sander make about an inch and a half blade in the upper side.
STEP 7 – Round all the corners and sides until smooth using a grinder.

I made it at TechShop

www.techshop.ws