Bottle Cap Atomizer Holder

Hi,

This very simple instructable shows how to make your very own atomizer holders, for literally nothing.

Let's get started!

Nothing fancy, really. You need:

• A bottle cap (or anything taller than the length of the 510 thread of your atomizer)
• A nail /a screw, to make an initial hole in the cap.
• A pair of scissors / a screwdriver / anything, really.
• (Optional) A drill, with a 7mm drill bit, to drill a perfect hole.

Being careful not to hurt anybody or yourself, use the nail/screw to puncture the cap, in order to make a starting hole.

Then, using your tool of choice, carefully enlarge the hole until you get to a diameter the 510 connector fits in. It's a good idea to test fit the atomizer every now and then, to make sure you don't go too wide.

If you're a pro, make the hole just right, so that the connector screws into it, and thus doesn't fall if you lift the atomizer.

That's it, you're done.

You can then improve the finished product, like gluing a piece of metal on the underside of the holder, to make it heavier, and thus sturdier. Also, you can make several of these, and glue them all onto a woodblock, for more pleasing aesthetics. Your imagination's the limit, really.

Happy vaping!